Products

PneuMoment™ Pneumatic Actuator

With eight PTFE impregnated bearing pads and a hard coat anodized load beam, the PneuMoment™ pneumatic actuator is capable of moving loads up to 700 lbs. and moments up to 7000 in-lbs. (Application and bore size dependent).  No lubrication is needed for the bearings, although standard air line lubrication should be used to enhance the actuator’s seal life.

  • Bore sizes for the PneuMoment™ pneumatic actuator:  1-1/16”, 1-1/2”, 2”, 2-1/2”
  • Standard stroke lengths:  1” to 15” (Custom stroke lengths available to 30”)
  • Maximum operating pressure:  150 psi
  • Auxiliary ports transmit air or vacuum through the actuator to operate automation devices
  • Available in U.S. customary units (inch) or metric
  • Built-in track for position sensing switches

 

Additional Specs Content

Pneumoment Specs

Common Cylinder Design Modifications

This table shows common modifications to our standard designs which have been provided to customers. Please contact your local distributor for information on pricing and delivery for these special options.

FeatureCommon Modifications From Standard Model

Rod

  • Longer than standard thread lengths
  • Turned down rod diameter; no threads
  • Extra rod extension on one end only of a double rod end cylinder (-DXDE)
  • Cross-drilled hole in the cylinder rod
  • Rod threads omitted where a standard NT option does not exist
  • Spherical rod end (no tolerance)
  • Female threads on the standard existing rod diameter
  • Screwdriver slot on rod end
  • Non-standard male rod threads that fit on the standard existing rod diameter
  • Omit wrench flats where they do not currently exist
  • 5/16" bore, single acting/non-rotating
  • Non-rotating, DXDE design (square rod on one end)

Body

  • Customer logo applied to the cylinder body
  • Omit Bimba logo
  • Mark the customer's part number on the cylinder body

Lubrication

  • Special lubricants (silicone, FDA approved, water resistant, Krytox, etc.)

Ports

  • Additional standard ports
  • Non-standard port size (when standard part will accommodate)
  • Ports rotated - other than 90°

Seals

  • Special compound seals (EPDM, Teflon coated, internally lubed, etc.)
  • Vacuum service
  • Special geometry seals (Quad seal, energized, lip seal, etc.)

Stroke Lengths

  • Greater than catalog maximum stroke lengths
  • Non-standard stroke lengths

Springs

  • Special spring forces
  • Omit standard spring(s), cylinder stroke length is reduced

Switch Tracks

  • Can be purchased separately from cylinders

End Caps

  • Anodized or Nickel Plated

Design for Clean Room

  • Special lubrication, seals, bushing vacuum port. Design does not conform to specific classifications.