Mid Series Venturi Vacuum Pump - VP10-MP

VP10-MP pumps have 4 vacuum ports that distribute vacuum equally to 4 locations with “Home-Run” plumbing. The streamlined design minimizes vacuum loss, maximizes vacuum flow and speeds cycle times for safe, efficient lifting operations. There is an additional port that can be plumbed to a compressed air source to provide blow-off, and the manifold design allows the one compressed air connection to feed blow-off air to all vacuum locations simultaneously.

  • High performance – vacuum up to 28"Hg [948mbar]
  • High flow – maintains strong holding force, overcomes leakage
  • Home Run plumbing – saves compressed air
  • Easy mounting – fractional and metric T-slot compatible
  • Safe operation – no electricity needed at pump
  • Reliable – non-clogging, trouble free operation

To order the VP10-MP Series Venturi Pump, click here.

Ordering Information


VP10-MP  Pump Standard Specifications

Pump Material: Anodized Aluminum (for silencer material see Silencer Page)

Cartridge Material: Nylon, Buna O-Ring, O-rings available in additional materials - Consult factory for availability

Medium:Filtered (50 micron) un-lubricated, non-corrosive dry gases

Operating Temperature:-30° to ~250°F [-34° to ~121°C]

Operating Pressure:80 PSI [5.5 bar] or 60 PSI [4.1 bar] – Consult Factory for other operating pressures

Performance Level Designations:

L”0-10”Hg, [0 to 677mbar] for low vacuum/high flow applications

M”0-20”Hg, [0 to 677mbar] for medium vacuum/high flow applications

H”0-28”Hg, [0 to 948mbar] for high vacuum/standard flow applications

VP10-MP Multi-port Mid Series Operating and Installation Requirements

Cartridge Size:C60 (M, H) and C90 (L, M, H)     C100 (L, M, H) and C150 (L, M, H)

Supply Line:1/4” O.D. [6mm] tube                       3/8” O.D. [10mm] tube

Vacuum Line:1/4” O.D. [6mm] tube                     3/8” O.D. [10mm] tube

Vacuum Line Filtration:Typically vacuum filters are not required, if desired Bimba recommends model VF125LPM (see In-Line Filter Page)

Control Valve: 3 way / 2 position (faster part release), minimum orifice – 0.125 I.D. [3 mm]

Mounting Screws: Mounting holes accept 4-40 [M3] screws